Rinnai 263 manual

See also: Service Manual , Conversion Manual. Table of Contents. This appliance may be installed in an aftermarket, permanently located, manufactured.

This appliance is only for use with the type of gas indicated on the Rating Plate. Previous Page. Next Page. Thank you for purchasing a Rinnai gas forced flue heater. Before using this product, please read this manual carefully to insure proper use of the product.

Please read the attached warranty thoroughly and keep it in a safe place. This appliance is only for use with the type of gas indicated on the rating plate. This appliance is not convertible for use with other gases, unless a certified kit is used. If a conversion of the unit is needed, conversions must be performed at Rinnai America or authorized agent at owner's expense.

Page 6 When provisions are being made to convert this unit, a certified conversion kit must be used. You must also readjust manifold gas pressure to specifications indicated in the conversion manual. If in doubt, contact Rinnai America for assistance. Center of hole must be located exactly at specified point. See diagram. Page 8: Specifications HI Do not spray aerosols while the heater is Do not install the heater in an unusually operating.

Young children should be supervised at all See page Page Installation Instructions Refer to local gas authority for confirmation of gas type if in doubt. Refer to data plate located inside of the front panel.

Check for damage. If the unit is damaged, contact your supplier or Rinnai. Do not install a damaged unit before checking with your supplier.

The gas supply line shall be gas-tight, sized and so installed as to provide a supply of gas sufficient to meet the maximum demand of the heater without loss of pressure. A shut off valve and appliance connector valve should be installed in the upstream of the gas line to permit servicing. This unit can only be used with one of the five types of Rinnai flue kits. Do not flue unit into other rooms. Flue terminal must be outside. The flue is not designed to be positioned under floors, or below the level of the heater.

Diagram below shows minimum clearances and distances from obstructions. Also check local regulations. Flammable Flammable Wall mm mm mm Opposite Disassemble Manifold from Sleeve.

Flanges The flue consists of 3 parts, sleeve, inside connectors and tube, outside terminal; disassembly by pulling hard on outside terminal and inner connections, then pull sleeve off outer terminal. Page 22 5. Check rubber seal is in place on terminal. Engage the hook and rotate it until it snaps against the body of the clamp. Attach the Air Inlet Hose to the flue manifold on either inlet position a or b.

Page 24 Top spacer the customer. Keep the power cord away from Top spacer the flue. This appliance does not have a pilot. Every time the Set Temp has been changed Set Temp that set temperature will be the latest data appearing on the RoomTemp Gas Type, Power Source, and Manufactured Date Type of gas, power source and manufactured date are displayed on the nameplate placed on the right side of the unit.

Do not use gas other than the type of gas gas group indicated on the nameplate. Page 29 In case of an emergency e. Tanks With Rinnai tankless water heaters, you never run out of hot water Rinnai tankless can last twice as long as tanks, making them a better investment as well as increasing the value of your home Rinnai tankless save money by using less energy and can fit almost anywhere in your home, saving valuable space Tankless The Rinnai difference year commitment to quality, backed by the industry's best warranty Financing options and rebates are available for most customers, making Rinnai tankless water heaters an even better value National network of trained installers and the first to manufacture in the U.

View Tankless Products. Businesses that depend on hot water rely on Rinnai. Our latest news New at Rinnai. Register your product Register Now. Are you a plumber?